Mechanisms | Emhartglass

Servo Electric Invert

Programmable profiles with adjustable starts, speeds and stops for improved invert and revert operations result in better container quality
Minimum revert time range: 320 - 350 ms
Increased cycle rates (up to 23 cycles per minute) and improved job change time and performance
Engineered to fit Emhart Glass section frames produced over the past 25 years
Can be integrated with T6000 and VLAN control systems
Compatible with Emhart Glass 191-5149 and earlier Neck Ring Mechanism (minor modifications may be required)
Can operates as stand-alone products with other Emhart Glass control systems or a competitor's
Patented SEI Technology

Improved cam design resulted in speed increase up to 37% during downstroke and 24% during upstroke
Less wear on blowhead arms and blowheads
Prolonged mechanism service life
Reduced inventories for blowhead mechanism and spare parts
Greater maintenance convenience
Compatibility with existing mold equipment
Externally accessible ball check valves
Enlarged air passages
Optimized upstroke piston rod cushioning
Integrated air and lubrication piping
Precise mechanism movement

Allows the preparation of a full set of identical blowheads prior to machine start-up
Enables faster IS machine operation through elimination of random hot/cold cavities
Gauges internal pressure, equalizing pressure and air flow, and allows all blowheads for a single job to be created equal and the entire set to be adjusted equally if desired

Patented system permits precise vertical alignment of deflector exit / mold center line
Cavity-based support system with its precise alignment provides smooth and centered gob transition into the mold - essential for high ware quality
Fully compatible with standard delivery equipment such as the scoop, trough and deflectors, and only the deflectors require minimal modification

Accurate gob loading

Reduces setup and maintenance time

Flexible and reliable

Readily installs on existing equipment