Emhart Glass представляет последние разработки в области инспекции стеклотары на производственной линии на выставке Glasstec 2008...
Ссылка на статью A0115

November/December 2008 — Glassmakers face daily manufacturing challenges with ongoing pressures for increased efficiency and cost reduction. Now they have two new quality assurance tools that will increase their plant automation efficiency and reduce costs…the Flexinspect BC and Flexinspect M, from Emhart Inex brand of Cold End Inspection equipment.

September/October 2008 — In some business situations capital expenditure is restricted, to the point where the purchase of highly sophisticated machines like the NIS or AIS is not commercially feasible. Sometimes, even the productivity from these machines is too high for certain market situations.

Traditional alternatives to overcome these problems are

Январь / февраль 2008 — Историческое нажатие кнопки свершилось в воскресенье, 30 сентября 2007 года, когда Стив Пинкертон, Вице-Президент по исследованиям и разработкам, включил 40-тонную печь в нашем исследовательском центре в Виндзоре, штат Коннектикут, США.

Сундсвалль, Швеция - 15 ноября 2007г., Мартин Йеттер, Президент компании Emhart Glass подписал договор с Panoramic Industrial Development Sdn. Bhd на проектирование и строительство помещения нового завода в Малайзии, включая покупку земли.

July / August 2008 — Vision ring inspection is now available for the Emhart Inex Veritas iM multi-station inspection machine. Designed to be installed at any of the machine’s three rotate stations, vision ring inspection uses a high-resolution camera with LED backlighting to measure finish T and E dimensions as the container rotates in place.

May / June 2008 — The Multi-Cam Feeder software for the FlexIS control system creates the possibility for a customer to produce containers of various weight on different sections of the same NIS, AIS or IS machine. When using the multi-cam mode, users are not limited to running the same cam/height/stroke combination for each running section. In a multi-cam configuration, the cam/height/stroke can be set individually. Multi-cam jobs can be created, controlled and monitored from a single screen.

March / April 2008 — Ware Handling is part of the Hot End Production where you can only lose! The forming is completed and the container is standing on the dead plate after the release of the take out. The challenge now is to bring the containers into the lehr without any loses and without creating defects on the containers.